FLYWHEEL PULLER M27 x 1.25, MOTOPLAT PULLER MX-12927

M27x1.25 R/H FLYWHEEL PULLER 27mm

Description:

• Fits Motoplat small internal rotor MX & ENDURO.
• Suitable for HUSQVARNA (FEMSA – BOSCH – MOTOPLAT) Most 1960-1970 2 Stroke Models w/C.D.I. Ignition.
• Compatible with KTM (FEMSA / BOSCH / MOTOPLAT) Most 125cc, 250cc 300cc, 360cc, 495cc XC & MX 2 Stroke Models, and most BULTACO, OSSA, MONTESA, PENTON, SACHS & MAICO [MP3].

Fits most:

• Husqvarna: 1970-80 2 stroke models with CDI ignitions.
• KTM: Current 2 stroke liquid cooled models.
• Classic: Ignition points with condensers or CDI Ignition Systems – Bultaco, Ossa, Montesa, Husqvarna, Penton, Sachs, and Maico.

Tips on use:

• Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
• Use copper grease on the puller threads for long life.
• Ensure the puller is fully screwed into the flywheel.
• After tightening, use a hammer on the center and tap to jolt free (not always needed).
• If using old flywheel pullers, make sure the threads are in good condition before use to avoid damage to the flywheel.